6th Gen Galant VR4 / E39A Triple 52mm Gauge Pod | Factory Clock Mount | No Dash Modification Required

This is a triple 52mm gauge pod mount for the 6th generation Galant’s. It utilizes the spot where the factory clock mounts to so you can have them at eye level for ease of looking. This pod sits flush against the dash and its curves for a cleaner look. Removal of your factory clock is required to use these pods. Installation is very easy and takes no less than 1 minute for full install (not including routing your gauge wires). Instructions will be included in your order on how to properly install these

These will fit shallow and normal depth gauges without any fitment issues. 

These are printed in ABS plastic and are capable of being prep’ed and painted if you choose so. ABS is more than enough to handle the extreme heat your dash can see in the hot sun

The faceplate is angled 8 degrees towards the drivers seat so you can get a better view of your gauges. 

It is recommended to use a rubber edge U channel trim to line the edge of the pod housing so you can keep your dash from wearing overtime and to keep your pod from possibly sliding side to side. These are designed to have a tiny bit of space in between the housing and the dash for this purpose. Any brand that fits over a 3mm edge will work. If you choose not to use this, you may experience some side to side play. You can buy the rubber U channel trim from Amazon or any other online retailer. There’s plenty of brands to choose from under 15$. 

There’s other ways to also do this such as foam tape, but I don’t advise using this since the tape will want to pull off under the strain from the tight radius it’ll have to bend over. There’s probably other ways to do this as well so feel free to experiment if you choose so

If you are wanting to order from out of the United States, please message me on Facebook here https://www.facebook.com/share/18Z9nXUi1s/?mibextid=wwXIfr